-
command entered: pip install rmd_x8
Response:
ERROR: Could not find a version that satisfies the requirement rmd_x8 (from versions: none)
ERROR: No matching distribution found for rmd_x8
-
Hi Tobit,
I am still investigating, but when using closed-loop position control for path-following (with commands every time step), my system tends to accrue many `myactuator_rmd.can.BusError` exce…
-
```
* checking running R code from vignettes ...
‘MatchIt.Rmd’ using ‘UTF-8’... failed
‘assessing-balance.Rmd’ using ‘UTF-8’... OK
‘estimating-effects.Rmd’ using ‘UTF-8’... failed
‘matchi…
-
I tried to use your code as a starting point. Currently i got the following feedback:
My set up: Adruiono UNO, Sparkfun CAN-BUS Shield , Can wires with 120 Ohm resistor, RMD X 8.
I can't con…
-
Hi Tobit,
I'm looking into ways to implement Motion Mode Control (i.e., send desired position and velocity with kp and kd and feedforward torque - 0x400 + ID in the control protocol). I've install…
-
Getting an error on this statement .. its saying SERIAL is already defined or the like .
Let me ask .. can I use this code with: an Adafruit CAM bus and an RMD-x10? It’s not a shield like yours the …
-
Melissa had the following suggested improvements for the interactive plots
1) order the sites in the legend from north to south not alphabetical
2) keep color consistent for a given site between ind…
bbest updated
3 years ago
-
I've run into a spot of trouble just this week when I try to reknit my vignettes for [{weatherOz}](https://github.com/ropensci/weatherOz) that are precompiled to reduce undue CRAN stresses due to need…
-
Hi
I run into the problem, that the qc_report fails because of missing R libraries. It would be great if you would write all the dependencies in the README. As is, a user must figure out, he can se…
-
Hello,
I noticed a small inconsistency regarding the constants of the X8-Pro-H V3 motor, which seems very low to me. In the X8ProHV3 class, the torque constant of 0.29 Nm/A probably corresponds to …