-
Would there be a possibility to store oscillator calibration for the Si4732? I made the mod and my device seems to be about 1.49kHz too low at 14MHz which practically inhibits tuning to CW on a somewh…
-
Hello Cec, I've also been working on writing a SI4732 driver for K5 recently. However, after testing, I found that your firmware provides better signal reception. The RSSI and SNR values I obtained th…
-
Is it possible to speed up the CW/SSB tuning?
Would it be possible to combine the VFO tuning and BFO tuning as to simulate a continuous 50Hz or 100Hz per step tuning? That would make SSB or CW tuni…
-
Hello phdlee,
I discovered your firmware here on github almost by chance. since I have a k5 dedicated to testing and a si4732 in the drawer, I'll try to put it in place of the original chip! I just h…
-
Hello!
When you turn on the radio, the si4732 chip is immediately supplied with power. When you hold down the "0" key, short wave reception is turned on; the supply voltage is also present on the chi…
-
-
Add code from https://github.com/phdlee/uvk5cec/tree/main
To add SI4732-A10 support for full hf
I realy want to add this mode but all the firmwares are basic and last luster , I don't want to s…
-
Hi,
I have a modded radio and would like to use this firmware on mine.
Will there be support for the Si4732 modification in the future?
-
Is the displayed value of the Bandwidth correct?
When I decrease the value from 6 kHz, it changes in the following order:
6 kHz -> 4 kHz -> 3 kHz -> 2 kHz -> 1 kHz -> 1.8 kHz -> 2.5 kHz.
When…
-
Is possible to merge with https://github.com/phdlee/uvk5cec ?
It implements nice spectrum analyzer / waterfall, please see videos here:
http://www.hamskey.com/2024/03/introducing-uv-k5-version-0…