-
### Is there already an existing issue for this?
- [X] I have searched the existing issues and there is none for my device
### Product name
smart water valve
### Manufacturer
Sonoff
…
-
Hi,
i am very new to this and i have to admit that i only know half of what i am doing here. But basically i wanted to integrate my Sonoff SC with Home Assistant. I did not want to use any hardware…
toco1 updated
6 years ago
-
Hi,
in my sonoff basic R2 I don't have GPIO14. Close to the 4 holes (3v3, gnd, rx and tx) I have a pad marked IO2, without the hole. And if I drill the hole, I risk to break the upper side tracks...
-
Hello, I have a problem that keeps me busy for some days. I have several Homie devices running at version 2.0. Thank you for creating Homie!
I try to setup a Sonoff Basic with Homie, flashing works…
-
Hi,
I have a 'spare' sonoff R1 and I am trying to flash cforth onto it.
I have read the notes
```
Sonoff S20 - WiFi mains switch with ESP8266 inside
FM=dout FS=8m make download …
-
**Name of Board**
Sonoff BASICR2 DIY Smart Switch
**Board Architecture (i.e: SAMD51, ESP32-S2, ESP32, ...)**
ESP8266
**Hardware URL**
https://sonoff.tech/product/diy-smart-switch/basicr2/
…
-
### The problem
I have updated my sonoff basic today.
After the update the sonoff was not available anymore in home assistant.
I bit the bullet and crammed it out the corner in order to reflash…
-
First time playing with Bubble-cards, and can't seem to get the pop-up cards to actually appear. I made a vertical stack and added a basic pop-up card. Any ideas? I am sure it's something basic I've m…
-
### The problem
I'm having problem with my sonoff basics updating OTA,
```
[D][ota:305]: OTA in progress: 0.3%
ets Jan 8 2013,rst cause:4, boot mode:(3,6)
wdt reset
load 0x4010f000, len …
-
Support for ESP8285 based Sonoff Basic would be very simple to achieve.
I made a custom build with a minimum of changes, and it works as expected.
Edited platformio.ini changing the env section as…