-
hello, everyone!!
when I enable the lbt in config file ,why the all down link frames are aborted by the sys?
SET:
"lbt": {
"enable": true,
"rssi_target": …
-
When I run the `lora_p2p_send` on a `NUCLEO-WL55JC1` in unoptimized mode, it doesn't work:
```
PS C:\Users\pragu\Documents\electronics\nucleo> cargo r
Finished dev [unoptimized + debuginfo] t…
-
You've heard of Semtech's new LoRa PHY models.
Support update for LoRaMac-node has been [released.](https://github.com/Lora-net/LoRaMac-node/tree/master/src/radio/sx126x)
Will the SX126x be suppor…
-
I noticed that when ral_get_lora_rx_consumption_in_ua is called. rx_boosted is always set to false.
Our PCB uses the sx1261 powered with a 1.8V power supply, the implementation to track consumption…
-
I cannot figure out which pins to set for the reset script.
spi and i2c are enabled.
tyro@rpiz:~/LR1302_loraWAN/LR1302_HAL/sx1302_hal/packet_forwarder $ ./reset_lgw.sh start
CoreCell reset thro…
-
DS_SX1261-2_V1.1, chapter 15.1 describes a known limitation with modulation quality when using 500kHz LoRa bandwidth.
Chapter 15.1.2 describes a workaround that is implemented here: https://github.co…
-
I am trying to setup the sx_1303 LoraWAN gateway as given in the official documentation. I have created my TTN account and trying to execute chip_id file but am getting following error:
CoreCell …
-
I've been testing your library on a SX1262 and I've seen that method 'setTxPower' fails for values lower than 14dBm.
I'm new at programming but I think that, on file "SX126x.cpp" -> void SX126x::set…
-
I'm working on an [application](https://github.com/brocaar/chirpstack-concentratord) which implements the SX1301/2 HAL as a daemon. One of the features is to re-configure the concentrator channel-plan…
-
Hi ,
Recently I got a sx1302 module with raspberry transfer board , I try to execute with compiling the open source sx1302_hal codes .I tried to test with test_loragw_reg , the result as follow …