-
https://www.amazon.com/JESSINIE-Serial-CH340N-Upgrade-Download/dp/B0CLD1THZ1
-
Is there any way to do so?
I'm able to change baudrate in the source code.
And say communication program to set specific baudrate (picocom).
But it seems 115200 is the only working setup.
It's…
-
Hi,
I lost the encryption key for esphome when I lost the previous HA config. The droplet gets reconized on the new install but I can't give it access to integrate without this key so I'm trying to…
-
在hal_uart.h文件中有这个配置
```
#define LINUX_UART_DEV1 "/dev/ttyUSB0"
#define LINUX_UART_DEV2 "/dev/ttyACM0"
```
如果不使用USB-TTL,直接用杜邦线连UART,需要如何配置
如果UART对应是/dev/ttyS0,将LINUX_UART_DEV1配置为/dev/ttyS0就…
-
### The problem
Since around 2024.04 two configured UARTs on a S2 Board will fail to boot.
It was working OK until 2024.03.
It is working with Arduino IDE
If either of the two UARTs is removed…
-
I don't know the details yet, but it spams `error -71` in dmesg. Will investigate with picoprobe later.
-
### The problem
ESP-IDF not handling the usb-cdc option.
Works with `type: arduino` just not `type: esp-idf`
### Which version of ESPHome has the issue?
DEV
### What type of installation are yo…
-
### Description:
My device sends data out over CDC ACM. When the host PC reboots the device is not (power) reset so it stays in this state. The host is not able to reinit the device so it's missing…
-
I moduli FT782 - convertitore USB/seriale montano un chip FT232RL, necessitano di un driver D2XX o VPC per funzionare su Mac OSX e Windows e si deve regolare la tensione su TX e RX scegliendo tra 5V e…
-
Hi all, this is my first time working with the Thread network protocol. I downloaded the ESP-Thread-BR example and flashed my ESP32-S3 WROOM1 micro-controller with the basic Thread board router exampl…