-
Hello. I tried to make a curtain with the motor that is written in the article, but it turned out to be too weak for my curtain. I have tried both 5 volt and 12 volt versions. I also changed power sup…
-
First a **_Great BIG THANK YOU_**:
issue: Two NoDelay's first delay works but second one fails to delay
_Most likely sometime in my code, I am no expert;_
Serial message shows function is ca…
-
### Testing configuration
* CommandStation-EX version: V-4.0.2 add-turntable-controller branch
* Turntable-EX version: 0.3.1-Beta
* Microcontroller: Arduino Nano
* Stepper driver: ULN2003
*…
-
Hi!
I'm using your project for my roller blinds. With the help of Gears the 28BYJ-48 holds up pretty well, but not enough.
I noticed the Stepper skipping/struggling when at full speed, but it works …
-
### Testing configuration
* CommandStation-EX version: 4.0.2
* Turntable-EX version: 0.4.0-Beta
* Microcontroller: Arduino Nano v3
* Stepper driver: ULN2003
* Stepper motor: 28BYJ-48
* Hom…
-
I wanna control setp motor 28BYJ-48 with 5pins out but how to set the initialize code, please?
-- with many thanks
-
Hi
Good news
I got it working,
There are now two working basic setup files in the test section which show who to use threading to turn two motors in parallel.
1. For Unipolar 28BYJ-48 Mu…
-
### Testing configuration
* CommandStation-EX version: 4.0.2 (add-turntable-controller version)
* Turntable-EX version: 0.3.1 Beta
* Microcontroller: Nano V3
* Stepper driver: ULN2003
* Ste…
-
### Testing configuration
* CommandStation-EX version: 4.0.2 (add-turntable-controller version)
* Turntable-EX version: 0.3.1 Beta
* Microcontroller: Nano V3
* Stepper driver: ULN2003
* Ste…
-
### Testing configuration
* CommandStation-EX version: 4.0.2 (add-turntable-controller version)
* Turntable-EX version: 0.3.1 Beta
* Microcontroller: Nano V3
* Stepper driver: ULN2003
* Ste…