-
How can I use APA102 leds with Tasmota? NeoPixelBus is support this leds.
-
## IMPORTANT
Before submitting this issue
[ ] Have you tried using the latest version of the library?
Ys
[ ] Have you checked this has not already been submitted and/or resolved?
Yes
[ ] If you …
-
I am using the uf2 bootloader (0.4.0) installed with Adafruit ESPTool.
Firmware downloaded from s3 and installed via uf2/KALUGA1BOOT:
adafruit-circuitpython-espressif_kaluga_1.3-en_US-20210625-5a4…
-
Is it possible to port to the nRF52840, at least for SPI LED types?
Although the nRF52xxx is similar to the nRF51xxx (which is supported), if I understand correctly, portions of the nRF52 core run …
-
Hi Guys,
I have just recently been testing TLC59711 on my nVidia Xavier NX dev board (might be worth mentioning that all other circuitpython libraries work fine on it).
Anyway when I tried to ru…
-
I'm having a hard time getting this to work on my ESP32 (DOIT DEVKIT V1). I have connected a string of WS2812B's, with the data port connected to GPIO23. My code is below, any help would be appreciate…
-
enable neopixel,
not work with ws2812 ?
WS2812 work with fastled lib, how to modify to use neopixel ?
-
People ask if CircuitPython supports interrupts. It does not support user-written interrupt handlers in the way that MicroPython or Arduino do. However, it of course does use interrupts internally for…
-
There is support for the 4-wire APA102 LEDs too. Need to test it before finalising #3 (should also check the pin-out for the APA102 strips to ensure it matches the 4-pin screw-terminal connector)
-
The Unexpected Maker FeatherS2 does not show the boot status via the onboard DotStar LED.
Was this intentionally omitted or should I look into implementing it?