-
Hi! I can't find any documantations about GPIOKeyCode,
what is it?
-
rtl_433 has great support for decoding various protocols and hardware support for few receivers.
MQTTGateway has great connectivity for various transceivers/receivers hardware solutions (and almost n…
-
-
Hello there,
I get RAW data from` -a` switch
```
*** signal_start = 492961, signal_end = 522029, signal_len = 29068, pulses_found = 140
Iteration 1. t: 30 min: 17 (80) max: 43 (60) d…
-
Hello there,
I would like to send a doorbell button push to mqtt. The rtl_433 is not decode it(the Pulse Analyzer not find it), but to be honest, it not required to me, because it is a simple butto…
-
I've just tested the https://github.com/telldus/telldus/tree/master/telldus-core code with the original Tellstick USB dongle, and noticed that rtl_433 could not tell the difference between the arctech…
-
Arduino Uno dirket per USB Kabel am Raspberry Pi angebunden.
433MHZ Empfänger XD-RF-5V
Empfangspin ist am Pin 2 (D2) des Arduino Uno angeschlossen.
Automatisches Device wurde in Fhem angelegt…
-
hello,
i have pir, rtl 433 see it "Kerui PIR Sensor", but another 433 reader see it in EV 1527... now rtl 433 see it "Wireless Smoke and Heat Detector GS 558".... i have tested this line "sudo rtl_…
-
Hallo lieber a culfw- Creator,
erst einmal vielen lieben Dank für die Enticklung dieser tollen Erweiterung für den CUL.
Leider funktioniert nach dem Flash der Firmware (Vormals "nanoCul 1.67" wenn…
-
Hi,
Would it be possible to listen to both the standard 0xA4 (Itead default) and advanced sniffing by predefined protocols (0xA6) concurrently? If possible, B1 bucket as well?
Use-case:
I hav…