-
Hi, not sure the schematic in its current form would work:
```
TXD --------|
-
After reports of many users that latest tnCartWonder bitstreams were not booting into their MSXs when using WonderTANG! V2.0b boards (and strangely my Panasonic FS-A1WSX and Toshiba HX-10 were not aff…
-
While I was reviewing the design, I have noticed that the `Serial 3` (sheet nº2) has not `GND` signal connected. This could be the reason why the port can't power up connected modules.
In this image…
-
### Environment (OS, Python version, PySpice version, simulator)
macOS, python3.12, PySpice 1.5
I'm trying to download PySpice on mac, using pip to install PySpice, and homebrew to install ngspi…
-
I think we should review this, so the pin colors are derived from either the general function of a pin (programmable, gnd, 3.3v, 5v etc), or the selected PinFunction.
And extend it to cover the fun…
-
Ran into an odd issue. It seems ngspice can handle a Spice model with "+" for additional input PINs but Qucs-S cannot.
~~~
.SUBCKT UC1825_TRANS OUT_B OUT_A ILIM-SD RAMP CT GND Vcc VC VREF NI INV E…
-
- [ ] improve GND routing close to L4, L7, L2
- [x] move switches 0.5mm from the board edge to avoid collision with the panel (THT pins trimming necessary)
-
电源和地
-
V modulu je snaha oddělit GND od GND základní desky. Na modulu se však nachází tato chyba:
![image](https://github.com/mlab-modules/SOLARMINIBAT01/assets/5196729/9edbd49c-8d85-406b-b1cf-117088f551…
-
I tried to install the deauther 2.6.1 on few esp8266 devices. Unfortunately the buttons are not operational at all. There are two Nodemcu 8266 v1 where the display (I2C) and everything else is workin…