-
Hi. How could I use the MKS-DLC32 to control a servo to use it as a pen plotter?
-
- Candle version: [1.1.7]
- Firmware version: [1.1f]
- OS: Windows 7 Professional Service Pack 1 64 Bits
I am modifying my Gerber file with FlatCAM program, I generate my .nc file and open it wit…
-
**Peter:** I was trying to speed up our lasercutter for engraving.
Using the following settings it engraves around the same speed as the native hardhard (Morntech).
motion.speed 800
motion.accel: 1200…
-
So, the B commands like B05 (which requests the firmware version) have to go if we want to be compliant with GCode standards and things like GRBL. I think the right thing is to move to something star…
-
#### Description
Feature Request to add a Widget for use in CNC. Where in the slicer is able to read the gcode for all top most values. Then adjust based actual measured data from supplied stock as…
-
GC assumes that when it makes a connection to the board running the firmware, the board will do a hardware reset. It uses a "change parity/close/open/close/change parity/open" reset sequence in seria…
-
I have tested IP function with GRBL Advanced it is connecting but GRBL-PLOTTER getting Stuck, also i have tested with IP testing software, same problem facing here also, just for your trial i have a…
-
hi,
Anybody could help me out, i have woodpecker 3.2 board using GRBL candle. status port opened and canoot control the cnc device...it just happened because i used ESTL cam and programmed it after…
-
**Firmware Version:**
1.3a Date 20210816
**Repeatable?**
Yes
**Conditions:**
- `$Stepper/EnableInvert=On` (e.g. for use with TMC5160 SilentStepStick drivers)
- Using an RC servo
- Custom ha…
-
Hello guys,
more than one time i tought to experiment some customization on the firmware, but i sincerely don't know where to start. I can write some basics in arduino, i'm not an expert, but it's ok…
gisep updated
4 years ago