-
What is the reason for this?
auxp updated
3 months ago
-
Hello, people -
I have what I think is a good puzzle.
GRBL 1.1h, 'real' Arduino Uno R3, ZenToolworks 12x12 CNC, Nema 23 steppers, TB6560 driver board. 24V 5A supply. Gantry has a LaserTree 10W…
-
Hello everybody.
I have a SKR PRO board that I wanted to use for a small CNC router project. I've been trying to get the trinamic TMC2209 drivers working for the past few days to no avail. The firs…
-
Good day
I came across your grblHAL_Backup for the MKS DLC32 after about a week of trying to get grblHAL on my board. Needless to say, the firmware works. So a big thank you for that.
I now ran …
-
Хочу сделать швейную машинку для вышивания..
как подключить (датчик индуктивности или датчик холла )для установки поднятия иглы ? и прописать его в прошивке
чтоб по команде в gcode m555 двигат…
-
While working on some macros that call other macros to keep code a bit cleaner, I am encountering some issues.
Firstly I am getting a lot of `error:39 - Value out of range.` when trying to call ano…
-
Short story:
Cannot issue a $X on a dry run of my first own grbl-hal build.
Always get "`error:79`"
Details:
- Try to setup a lathe controller on a blackpill.
- STM32CubeIDE, flash with a st-Li…
-
Hi and sorry for creating another issue.
I just cant get my head around why the motors are not working. Ive got 5160 ez on my octopus max. In the First 4 Slots.
Ive compiled on the webbuilder wit…
-
here is a long winded video of me bumbling through some testing. I didn't test edge finding prior to today. Corner finding works well, as does center finding. I'm guessing you didn't put much time …
-
I need for esp32 BOARD_MKS_TINY
change the pins.
with the official map, the fact is that I’m installing Web Builder, not all pins are correctly set for the laser; you need to change a little to ad…