-
Aufgrund eines Betriebssystemwechsels (Buster -> Bullseye) mussten diverse Homematic Geräte mit umziehen. Hierzu habe ich ein Backup vom alten System in das neue eingespielt.
Alle klassischen Homem…
-
### Describe the issue you are experiencing
With docker Image version v3.65.11.20221218 RaspberryMatic is not starting completely and it is running slowly with high CPU conssmption.
The following …
-
### Describe the issue you are experiencing
Since the upgrade to HASSOS 9.0, the add-on cannot start. I suspect this is due to the docker migration to cgroups2.
Error message from the Supervisor:…
-
Hi,
I just finished the HB-RF-ETH with PoE and powered it on the first time. The device is getting power but there is no LAN connection. When connecting via USB and LAN (without PoE) running the se…
-
### Describe the issue you are experiencing
Nachdem ich bei einem meiner HMIP-WTH-2 die Batterie tauschen musste, kann das Gerät nicht mehr über die Zentrale gesteuert werden --> Servicemeldung Gerät…
-
Meine HB-RF-ETH0 bekommt keine Netzwerkadresse mehr, die grüne LED vom Board leuchtet aber. Update via WebUI ohne IP natürlich nicht möglich, Factory Reset hat auch keinen Erfolg gebracht.
Nun habe i…
-
Hello,
Is it possible to dynamically close a connection to a board ?
if yes, can you explain me how?
Thanks and Regards.
-
I just tried to use a [HB-RF-USB-2](https://github.com/alexreinert/PCB/tree/master/HB-RF-USB-2) for the first time on my host.
`detect_hardware.inc` was unable to find or use the device because the…
-
Hallo,
ich versuche gerade der Platine HB-MOD-UART-USB eine SMA Buchse wie bei der HB-MOD-UART hinzuzufügen.
Da ich aber noch nie mit Kicad gearbeitet habe verzweifele ich daran schon den ganzen A…
-
Hallo Herr Reinert,
aktuell habe ich mit nachfolgender Konfiguration das Phänomen, dass alle meine Unterputz Schaltaktoren als Ein-Kanal-Aktoren erkannt und typisiert werden. Witzigerweise kann ich b…