-
### Issue description
A player on my server is trying to setup their Tritium production for their Fusion reactor. However, their TEPs are not being heated by the connected resistive heaters. We've tr…
-
I need to replace my cartridge heaters, does anyone have a source for them ? or if someone knows the exact spec I can just source them.
after a terrible jam that left my head full of ABS, I need to r…
-
### Is your feature request related to a problem? Please describe.
Solid state relay(SSR) based heater.
Brief:
1. SSR based heaters work directly from mains voltage 50Hz or 60Hz
2. SSRs usually …
-
We repeatedly get questions about our calculations for transport demand. It would be efficient to write this down once properly and then be able to refer people to our documentation.
The main quest…
-
### What happened?
Namron Panel heater model 540139X
The energy value has bad readings at some points of the day, sometimes higher and sometimes lower than the real value.
I have 7 of these heate…
-
As discussed here: https://github.com/quintel/etsource/issues/1386#issuecomment-397301382 Refinery heat costs should not be taken into account in the total cost calculation to avoid double counting.
…
-
### Prerequisites
**TRVs**
Moes BRT-100-TRV
**External temperature sensors:**
Tuya/Moes TS0201
### Description
I use to switch the heating system on / off the hvac_action state of the BT…
-
Hello!
If Printrun gets closed it disables extruder heating even if printer is currently printing something from SD Card. Such behavior can ruin print if not noticed in time. This should be removed…
-
Deear, I have an extension Homecontrol IO connected to the cozytouch working fine. I also have two Sauter Heaters directly connected to cozytouch and they are showing up and working well so far.
Ba…
-
So I recently installed the E3 turbo on my Ender 3 V2 and it has been working great everything works until I tried to print this carbon fiber filled polycarbonate blend.... 90 c bed temperature and 26…