-
Hello
I am fairly new to CAN messaging and have inherited a codebase that uses this library to grapple with a CAN bus that uses the SAE J1939 protocol.
I quite like this library's feature of par…
-
OI IsoBus support. Some people surprisingly still use this.
-
Which tractor uses this PVEA-CI?
Regards
-
Hi, I was reading the Klipper CAN code and noticed that it is not using any protocols to send anything more then 8 bytes. This is not error proof especially for the "Waveshare Raspberry Pi CAN hat", t…
-
As a developer I would like to add a system test to check that the USE_ISOBUS macro works correctly. This would also be a good opportunity to move the emulator + tests to the support dir to match the …
-
i use a TWAI on Pin 19/20 on ESP32S3.
ESP-IDF v4.4-rc1
chip revision: 0
CONFIG_EXAMPLE_TX_GPIO_NUM=19
CONFIG_EXAMPLE_RX_GPIO_NUM=20
when try to send CAN MEssage i get:
E (1153) TWAI Master:…
-
As a WISH scientist I want to be able to control any of the 7.5T, 9T, 10T & 14T Oxford Instrument magnets.
#### Acceptance Criteria
1. Using IBEX, I can select and use configurations for any of th…
-
WISH needed ISOBUS addresses for their Teslatron magnet to be updated after changing equipment. However afterwards, they ran into a problem where parts of the equipment stopped responding correctly, n…
-
As an instrument scientist on IMAT I want to be confident that my dilution fridge experiment will work. As such I would like to test it on my beamline before hand.
## Acceptance Criteria
* IMAT ha…
-
Hello,
ESP-IDF Pre-release v4.1-beta2
running Example
https://github.com/espressif/esp-idf/tree/master/examples/peripherals/can/can_network/can_network_master
with
CONFIG_ESP32_REV_MIN…