-
I try to debug the simple example of `/gap_sdk/examples/pmsis/periph/uart/uart_helloworld` using VSCode as described in the `VSCode Integration` sectoin of the manual. However, there seem to be no con…
-
Installing this package fails with the most recent ameba-arduino package (2.0.2), due to dependency issues. Also, there aren't host identifiers listed for linux hosts.
The following patch fixes the…
-
Hi, have some problems, I think is clock speed...
c232hm-edhsl-0.cfg
interface ftdi
ftdi_vid_pid 0x0403 0x6014
ftdi_device_desc "Single RS232-HS"
adapter_khz 2000
ftdi_layout_init 0x0008 0x400b
…
-
Hello,
I am using Ubuntu 18.04, installed openocd 0.10.0 via apt-get, cloned this repo, bought a STlink 2.0 adapter and nrf51822 board similar to the one in the README photo, but when running the s…
-
My update failed. After finding my Bubble device I started the upgrade. The bubble LED went red but the firmware download dont start. The app is waiting at 0% and reports after short time: Failed. Aft…
-
Hello,
I have successfully build and uploaded Freedom E300 on my Arty Rev. C board using Vivado 2018.3. OpenOCD can detect the core but when I send telnet command to it, it returns ```Error: Target n…
-
I built the acorn.py for both the CLE-215 and the Alientek board,
and I get in both cases the same symptoms:
```
$ litex_server --jtag --jtag-config ft232.cfg
Open On-Chip Debugger 0.12.0
Lice…
-
I'm having issues getting the Arduino sketch to upload. I followed the instructions and my device shows up as COM( B-L072Z-LRWAN1). Here is the error report I'm seeing:
****************************…
-
During the programming of the device, the bootloader was probably damaged. The device is recognized correctly in the system, but the bootloader does not present itself, and it is currently impossible …
-
### Board
ESP32C3 Dev Module
### Device Description
ESP32C3 Dev Module is selected for the board.
The physical board uses Seeed Studio XIAO ESP32C3.
### Hardware Configuration
Built-in USB only.…