-
### The problem
Randomly on starting a print it goes through the heat up fine, bed level runs, but instead of the purge line it goes to 0 0 and keeps going, the extruder runs at the same time firing …
-
I would be nice if there was detection on the extruder motor, so if the filament got stuck outside the printer, eg. on the spool holder, it would sens it and pause the print and ask f…
-
Where do i find and change limits for Z OFFSET for the LCD?
I would like to change Z offset to -0.2 but u hit the limit in (-)000.50 in the LCD and it wont go below that.
I can set the limit by send…
-
Hi:
I send a error G command by serial. for example: I send 'G1 DDRE' by serial. FW return 'ok' . all 'G' and 'M' start string be send to FW, receive 'ok'.
marlin 1.1.3
-
Following your code, I'm required to install ggimage to use geom_image to map and plot the logos. With that, I cannot control the transparency of the images. Otherwise R/ggplot does not recognize the …
-
### Is your feature request related to a problem? Please describe.
Right now, most printers do not appear to have hardware interlocks to prevent compromised firmware from causing physical damage or u…
-
I am trying to use a Dyze 500 (from Mellow) thermistor.
According to [https://dyzedesign.com/support/temperature-sensors/](https://dyzedesign.com/support/temperature-sensors/) i defined :
```
…
-
### Brief description of the issue
A question mark is shown instead of Inverted commas and Arabic/Urdu font. Most probably these strings are not escaping properly.
### How to reproduce the bug?
…
-
Hi,
I trained BlenderBot2 3B with the option of `inference` set to `nucleus`. In all the example training scripts I've found in ParlAI's github issues, the inference is set to beam. I initially th…
-
I tested lin_advance and like the WIKI says it is recommended to
> Ensure your print host software is using line numbers and checksums, this is disabled by default in Simplify3D.
so i enabled it in …