-
Hi,
maybe someone will help me or will give me some hints.
Iam using OT gatway and rsciriano ESPHome-OT with Viessman 100w combi boiler.
Ive tried v0.1 to v0.3.
Iam using node-red and ca…
-
### The problem
when i call the service to set sensor.otgw_dhw_ovrd_gateway_otgw 1 and 0 seems to work fine, but when is send the command "A"the sensor gets unavaible until i reload the opentherm gat…
-
Home Assistant log asked to report this packet.
21:041873 is a Spider Thermostat connected by OpenTherm to my Heat Pump (Itho Daalderop WPU 5G).
It is also wireless connected to a Itho Daalderop A…
-
Another problem is that settings are not saved in EEPROM memmory on ESP8266. After power lost I have Usage Water Off and set to 25C.
-
Hello @Laxilef, Thank you for the work, everything is just great.
I encountered a problem where after entering the settings - they are saved on the device, but reset in the settings panel to defaul…
Quiss updated
3 weeks ago
-
**Describe the problem you have/What new integration you would like**
I would like to have a default value and restore-on-reboot system for the number component. I see this as similar to the …
-
-
**Description of setup:**
Evohome controller, connected to Remeha Elga Ace heatpump with R8810A1018 (Opentherm module)
Firmware version: WiFi module: 02.00.17.00, Application module: 02.00.19.33
…
-
Honeywell / Resideo introduced the HCC100 underfloor heating controller. I installed it as part of my Evohome setup, replacing my HCE80. Would it be possible to add support for the HCC100 in **ramses_…
-