-
-
I recently flashed my ANTSDR E310 device with the newest firmware image (v1.4.0). However, I'm unable to connect to the device via SSH and pinging the device returns "destination host unreachable." Wh…
-
TL;DR: I have a more comprehensive and exhaustive scan with iwlist wlan0 scan than using `wifi.Cell.all('wlan0')`.
The point is: This is random. Sometimes, the module shows all available networks. So…
-
-
By analyzing openwifi-hw and sdr.c, we think openwifi_tx_interrupt using the s2mm_intr as the interrupt signal. But the s2mm_intr is related with the Rx, which means it only occurs when data is receiv…
-
Hi,Dr Jiao
I tried to get both boards to work in ad-hoc mode, but by ILA signal grabbing, I found that the modulation on the transmitter has always been BPSK (grabbing the rate of the dot_11 in the o…
-
焦博士您好!请问为什么将两块板子用同轴电缆相连,也会丢包,并且将最大重传次数定为1时,两块板子用同轴电缆相连丢包率达到了7%,丢包的问题大概会出现在哪些地方?
-
I am reaching out to address an issue I've encountered with the uImage in the new kernel version, which seems to be having trouble recognizing modules from the previous kernel version.
Upon further…
-
When I use OpenWiFi for Batman-Adv networking, I find that nodes cannot discover each other. I couldn't find a problem, so I configured the mesh directly between the nodes as follows
->iw dev sdr0 in…
-
openwifi currently uses FDD mode to realize simultaneous receiving and transmitting, but when AP is working, I find that their receiving and transmitting frequency Settings are the same. Isn't FDD req…