-
# Series: Build Power Apps that don't look like Power Apps - Material Design part 1
One of my most important goals when developing Power Apps is good design.
[https://pnp.github.io/blog/post/build-p…
-
### Describe the bug
My Rig has two displays with two different refresh rates. Primary LG 1440 165 hz & 24 inch Wacom Cintiqu 4k 60 hz.
### What did you expect to happen?
After updating to Bazz…
-
IDENTITY, JACOBI, SCHUR_JACOBI and SCHUR_POWER_SERIES_EXPANSION preconditioner should all be possible to run on the GPU relatively easily.
The key idea is to export E, F, inverse(E'E), F'F and inve…
-
**Describe the bug**
A clear and concise description of what the bug is.
**To Reproduce**
Steps to reproduce the behavior:
1. Run `sudo dnf copr enable epel-9-x86_64` and 'sudo dnf copr enable c…
-
Its certainly clear to anyone looking at the datasheets of the opto-mos and HV opamp that a short circuit will kill them. But let's put a warning on the front panel that the outputs are not short circ…
-
This works
```
sage: R. = ZZ[]
sage: sqrt(1+x+O(x^5))
1 + 1/2*x - 1/8*x^2 + 1/16*x^3 - 5/128*x^4 + O(x^5)
```
One would expect this to work:
```
sage: R. = ZZ[[]]
sage: exp(x+O(x^5))
Traceback (…
-
I only have a Mustang LT25, and I suspect there are differences among the other amps in the series.
The other amps are:
- Mustang LT50
- Mustang LT40s
- Rumble LT
To ensure compatibility, all that w…
-
### What is it?
Currently we have these legacy `code_metrics_by_project`, and `onchain_metrics_by_project` computed in dbt.
With the new metrics factory on sqlmesh, we should create new models. …
-
```
sage: R. = GF(2)[[]]
sage: f = x + x^2 + O(x^5)
sage: exp(f)
---------------------------------------------------------------------------
ZeroDivisionError Traceback (mos…
-
When connected to a Control+ hub, my large spike prime motor works properly, but when connected to a Boost hub, even manually sliding the power slider does nothing on both c and d ports. I am using th…