-
Hi,
I got some problems with the board of automodel car V1, How can I get or purchase a new one?
The problem is that after I press the green button for three seconds, the entire board don't stays e…
-
### The problem
After flashing a [Shelly-Plus-1PM](https://www.esphome-devices.com/devices/Shelly-Plus-1PM) via Tasmota OTA (initially installed Tasmota on that device) using a stripped configurati…
-
Hello
Again thank You for the job :)
I've uploaded v.08 to espurna board but I still can't keep the values entered in the calibration permanently.
After using telnet and get pwrRatioC i got this…
-
Relay 2 does not turn off 9v pin on flight controller.
Assigned CH8 to relay 2. Verified relay 2 is associated to GPIO pin 81. Tried different relay default options with no change. iFlight …
-
Hello, i was wondering how would i go about connecting **Relay** to the board in a way that would Turn on at the same time as laser engraver.
In the past i tried connecting standard relay to the t…
-
I've been trying to use the CAT image to control a relay board. The webpage is there but it doesn't seem to do anything on the actual boar. I also tried manually activation the GPIO thru the sysFS b…
-
### CircuitPython version
```python
Adafruit CircuitPython 9.0.2
```
### Code/REPL
```python
import wifi
import adafruit_connection_manager
import adafruit_minimqtt as my_mqtt
cert_file = mqt…
-
Hello! Imagine that I set up PiOT Relay Board in handshake mode for it to be activated only after sending pulse train on the specific GPIO pin. My application is written on Python 2.7 and runs under R…
-
This family of boards ([example on AliExpress](https://www.aliexpress.com/item/32919575201.html)) is extremely common, they feature an ESP-01 that communicates with a STM8S103F MCU on the board throug…
xates updated
2 years ago
-
Repeated the grbl_esp 32_cnc_controller v1.2.1 Board. I Use a CNC engraver with the ability to connect a milling cutter and a laser. When using the relay to switch the router in the firmware we use pi…