-
### Feature description
I suggest giving the servo the ability to give inversion/several positions (for example 10 and -10)
### Feature purpose
to have more options for engineers. for example, mech…
-
Klasické řízení serv přes PPM signál neumožňuje ze serv získat zpětnou vazbu o jejich stavu.
Jednou z možností jak tuto situaci vyřešit je vyměnit elektroniku v servu za vlastní, která umožňuje obou…
-
I want to use a servo instead of the Z-Axis Stepper motor. The servo would be PWM controlled which is something the ESP32 firmware can support on every GPIO pin.
Is there any GPIO pin from the ESP3…
-
**unable to configure PWM on teensy 4.1**
i am trying the "samples/basic/servo_motor" example for teensy41 board, below have attached the overlay for teensy41 but when i build the same i get error.…
-
So I’m designing a MMU unit that doesn’t have gates, but instead uses a servo to set an idler(like the mmu2) to the correct position(set angle) and then has a merger with a sensor at the exit like a g…
-
**Describe the bug:**
Android version crashes at startup on GrapheneOS with memory tagging enabled. (Works without memory tagging)
**To Reproduce:**
1. Install APK (SHA256:df461587b4898a42f443a19…
-
hi
i see in the coding the servo part is there
how to i add it to the index.html so it turns the servo
-
https://www.eevblog.com/forum/mechanical-engineering/programming-hitec-d485-rc-servo-settings/
If link goes dead. Archived copy: https://web.archive.org/web/20240511095348/https://www.eevblog.com/f…
-
The current settings and limits coming from the Betaflight FC are being interpreted such that even with the PWM output at full, the motors are still not spinning enough to enable flight.
-
Need the servos to work as described in prior communication. X_o to X_F when "s" is fired.
whfel updated
6 years ago