-
I am using Visual Studio Code 1.72.2 and PlatformIO 6.1.4. The board I am using is the Sparkfun ProMicro16 based on the 32u4. When compiling the example MIDIUSB_write.ino, I get the following warnings…
-
Are there any plans to support the Arduino Nano Every? I just got one and was annoyed that FastAccelStepper doesn't work on it (I somehow did not notice that it uses a different processor from the Ard…
-
Greetings.
It appears you might use some help with maintenance of the project.
What would it take for us to set up a little release process and delegate some repository maintainers to get some t…
-
Hi, I am trying to use your debugger in a simple code using a custom board with and Atmega1284p, but I am not able to get it to work. I tried getting the optiboot bootloader and changing the Make file…
-
Hi,
the following code for mega1284P configures the USART1 as SPI-master and sends out the same byte again and again (stop the simulation with Ctrl+C!) at maximum speed=f_osc/2. It also sets a pin …
-
I recently started playing with an Atmega8 MCU, which uses the AVR instruction set and has only 8KB of program memory, but despite this fact I still wanted to try async Rust on it, which led me to thi…
-
Sadly the original developer of the software does not comply with the common programming best practices. He used to publish binaries and zip files on SourceForge, then he switched to his blog. and rig…
-
I am trying to get 9N1 to work. [1]
Modifying the uart-loop-testcode to use the parity bit does not work.
On sending, TXB8 will be set.
Inspecting the gtkwave file, the parity bit will not be set d…
-
Everything is working great but it's not capturing caps or special characters...it's just logging as if the shift key wasn't pressed...am I missing some setting I need to specify in the code to enable…
-
The tracing support seems to be incomplete. Specifically:
(1) I can't find a way to trace (or otherwise access) the USUART
output. The portpin trace kind seems to work only with GPIO output.…