-
![Mis-labeled BHSC pg 70](https://user-images.githubusercontent.com/7052158/226932289-0e6b0f5f-adfd-4fb9-8ff9-01730405adf9.jpg)
-
page 214 says prior to tightening **don** the fasteners. not DOWN the fasteners. small typo
-
The length of the reverse bowden between the motor panel and the toolhead should be around 300 mm, not 200 mm as the manual suggests on page 227.
-
At page 52 of the manual it says to "Remove Uprights" with no indication of whether or not you should keep the screws in our out during the removal process. Though when you make it to page 54 it assum…
-
Mod in question https://github.com/VoronDesign/VoronUsers/tree/master/printer_mods/ommy/roller_brackets
When I tried to mount the roller Brackets, the brackets lift the printer about 5mm, resulting …
-
It would be very nice to have a (official) model for a V0.2R0 (2mm shorter) filament sensor foot in the repository. Either in the 0.2 or 0.2R1 branch. Because of how the height was increased, it is un…
Kagee updated
10 months ago
-
Ive recieved the following once im trying to enable yr display.
How to update it?
MCU Protocol error
This is frequently caused by running an older version of the
firmware on the MCU(s). Fix by…
-
Middle diagram is missing 2 heat set inserts at the top.
![image](https://github.com/VoronDesign/Voron-Trident/assets/59866/3d386e15-3786-483d-9fd8-0c491ee21f51)
I realize that these instructions …
-
It would be good to make a groove under the Z linear guides. Since according to the instructions for voron 2.4 r2, the gap from the bottom is 3 mm, and the plug is 5 mm high and does not get up normal…
-
@samwiseg0
According to the BOM for v0.1, The PSU should be a LRS-150-24..
The following mod is marked for compatibility for the V0.1 when there is no PSU cover for the LRS-150-24.
https://g…