-
AEM has support for AEMNet/CanBus integration for communicating with third party devices. Here's the corresponding documentation for it, specifically at pages 10 and 11.
[techlibrary_30-0300_x-ser…
-
Hi Adam,
I've watched your internet tutorials with interested, hence the approach here.
Some help is much needed and appreciated. I'm a 45 year old disabled man that lives in Faringdon, Oxfords…
-
Let me explain. All my boat came with raymarine equipment, everything using Seatalk1 network.
Before I updated to SignalK 2.7.1, those messages were working perfectly fine, updated on the data bows…
-
RC Firmware must be changeable too.
Some limitations was added with RC Firmwares 1.6 and newer.
Output Power is reduced from 25mW to 10mW in CE Mode.
And
It should be possible to change CE to FCC Mo…
-
Hi there! Love the project :)
Is it possible to pull the Forward, Backward, Brake, and Buzzer statuses through CAN instead of GPIO? This would reduce the amount of wire connections needed if one us…
-
Hey George,
I love to see what you are doing here and I'd wish to try the system. But at my place we only got BMW's. These also have radar-sensors and adaptive cruise control.
What is needed to …
-
### Describe the bug
I'm using C3x with L&P harness and latest release of OP. L&P harness is functioning properly. C3x device states Cruise Fault: restart car to engage. Turning off car does not reso…
-
### Describe the bug
When building for an AVR-based 3D printer, `klipper-firmware` fails, throwing an error during linking stage:
```
avr-objcopy -j '.compile_time_request' -O binary out/src/av…
-
Hello Bennet
Please can you help with the below, I can install on a vanilla rasp image but when I try to install on existing open auto setup it does not seem to be able to start the webservice. I …
-
I performed an update a few hours ago and now moonraker appears to be crashing every few seconds. A consistent experience across browsers is that the Mainsail or Fluidd interface will load, allow for …