-
**Impacted versions:**
16.1+e and higher according to current runbot versions.
**Steps to reproduce:**
See for yourself.
**Current behavior:**
Subscription invoicing options dissapeared a…
-
I have `_TZE200_uiyqstza` devices. When on the TRV the boost mode is enabled (`operation_preset`), then `set_temperature` fails with an error. In my setup it is triggered by [BetterThermostat](https:/…
-
Probably better to share these graphs here and not on HA forum.
As promised some further graphs. I set aggression to 3, overshoot to 30. To note, until 7am the heat pump was in night mode, capping …
-
I noticed that my Tuya devices go into "unavailable" state. After reloading, integration is restored for some period.
Diagnostic for device that goes to unavailable state most often:
```
{
"…
-
I have this simulation which is currently exploding without any apparent reason. After 1800s the simulation explodes without any apparent reason (results seems smooth, RAM is not saturated nor is the …
-
### The problem
I' ve added custom virtual MQTT HVAC with modes: auto, heat, cool, off.
Everything works properly, but after off state turning climate entity on by service climate.turn_on always s…
-
Hi All,
I just took possession of the above new device that appears to be the new version of the old device - the pics on the Itead website has not even been updated.
This board is based on the …
-
I am trying to setup echonetlite for my ceiling fan that uses echonetlite protocol. but it seems that i am getting a keyerror when adding my device
any help or direction is greatly appreciated!
…
-
Been a while since I noticed this but my Ecobee has never shown these modes in thermostat page as selectable so thought I would report this.
![image](https://github.com/Blackymas/NSPanel_HA_Bluepri…
-
Currently, LG airco devices have an optiong to set a swing mode using one switch. This switch sets swing mode for horizontal and vertical swing.
The status is reported as swing_mode_horizontal and s…