-
This is a request to enhance the OctoPrint graph adding additional Firmware Temps.
Klipper FW allows the user to configure additional temperature sensors: https://www.klipper3d.org/Config_Reference…
-
Foreword: I'm super new to 3D printing, Raspberry Pi's, Linux, etc. Please explain like I'm 5, I will not be upset. I know enough to be dangerous, but probably not enough to come up with this solution…
-
environment:
- TwoTrees Sapphire Plus printer
- MKS Robin Nano 1.2 board
- 3x2208 (X,Y,Extruder) + 2x2225(Z, Z1) TMC Stepper drivers - using 2208 for 2225 as per comments
Configured in Printer…
-
I’ve assembled the Klicky probe today and I have some questions/remarks that might help improve the already excellent instructions even further.
I had planned to use the automatic Z calibration and …
-
BLtouch i working but query_probe always report probe open
I spend so much time fallowing documentation https://www.klipper3d.org/BLTouch.html but probe was always showing open then i found some info…
-
I want to use BLTouch in the ender3V2 in Klipper , but i don't know the pin number.
This is the picture, thank you .
![image](https://user-images.githubusercontent.com/95208444/143831600-f97580fa-92…
-
## Affected Version(s):
- klipper version: v0.9.1-670-gfa7a91a3
- moonraker version: v0.7.1-34-g5522e15
- fluidd version: v1.16.2
## Platform:
Raspberry Pi, linux
## Hardware Configuration:
…
-
I think it would be very useful to be able to chart arbitrary values with basic custom annotations. For instance, I think the maximum flow rate of my printer is 16 mm3/s. A plot with both flow rate an…
-
hello everybody
I have a 3Zcorexy. I changed my bigtreetech Skr1.3 contorller board to Octopus ,my Printer_Config refer to https://github.com/bigtreetech/BIGTREETECH-OCTOPUS-V1.0/blob/master/Octopu…
-
I can not figure out what is going on. Keep getting the following error:
_Heater extruder not heating at expected rate
See the 'verify_heater' section in docs/Config_Reference.md
for the parameter…