-
```
APM must not apply any pulse width which is either higher or lower than the
present radio Transmitter.
It is observed that APM 2.26 AND 2.27alpha, have this proble. WHATEVER PULSE
WIDTH I CAN A…
-
This would involve checking to see if encoder is moving a significant amount, when power is above some certain level. If it isn't moving for a specified period of time, the motors should be turned off…
-
```
What steps will reproduce the problem?
1. Uncomment dualcopter in version 2.3 and upload to mega board
2. connect motors to pins 3 and 5 and servos to pins 2 and 6
3. servo connected to pin 2 does…
-
```
What steps will reproduce the problem?
1. Uncomment dualcopter in version 2.3 and upload to mega board
2. connect motors to pins 3 and 5 and servos to pins 2 and 6
3. servo connected to pin 2 does…
-
```
What steps will reproduce the problem?
1. Uncomment dualcopter in version 2.3 and upload to mega board
2. connect motors to pins 3 and 5 and servos to pins 2 and 6
3. servo connected to pin 2 does…
-
```
What steps will reproduce the problem?
1. Uncomment dualcopter in version 2.3 and upload to mega board
2. connect motors to pins 3 and 5 and servos to pins 2 and 6
3. servo connected to pin 2 does…
-
```
What steps will reproduce the problem?
1. Uncomment dualcopter in version 2.3 and upload to mega board
2. connect motors to pins 3 and 5 and servos to pins 2 and 6
3. servo connected to pin 2 does…
-
```
What steps will reproduce the problem?
1. Uncomment dualcopter in version 2.3 and upload to mega board
2. connect motors to pins 3 and 5 and servos to pins 2 and 6
3. servo connected to pin 2 does…
-
```
What steps will reproduce the problem?
1. Uncomment dualcopter in version 2.3 and upload to mega board
2. connect motors to pins 3 and 5 and servos to pins 2 and 6
3. servo connected to pin 2 does…
-
```
What steps will reproduce the problem?
1. Uncomment dualcopter in version 2.3 and upload to mega board
2. connect motors to pins 3 and 5 and servos to pins 2 and 6
3. servo connected to pin 2 does…