-
-
**Is your feature request related to a problem? Please describe.**
Sometimes ironing is only needed on a particular surface. Adding modifiers to achieve the desired result can be tricky, and if ironi…
-
@mousebrains the diss_inspector is incredibly useful, thank you for making it! After playing around a little, I have some suggestions for rearranging the plots. In the figure with diss plots, instead …
-
Hi Trent & Emma,
This is a great innovation. I have been tinkering on similar ideas when I stumbled around SNAILS. Have you tried it on the ONT ligation kits?
Please do let me know.
Thanks,…
KS741 updated
2 years ago
-
I try to control the joint velocity by sending message to `/iiwa/command/JointVelocity`. However, when the velocity is small, the motion is jerky.
There are camera an force sensor on the end-effecto…
-
### Make sure you are using the *latest* version: run `youtube-dl --version` and ensure your version is *2017.09.02*. If it's not, read [this FAQ entry](https://github.com/rg3/youtube-dl/blob/master/R…
ghost updated
3 years ago
-
```
Using the following command line:
gource -r 30 -1280x720 -s .5 --disable-progress --stop-at-end --highlight-users
--output-ppm-stream - input.gource | ffmpeg -y -f image2pipe -vcodec ppm -r 30
…
-
```
Using the following command line:
gource -r 30 -1280x720 -s .5 --disable-progress --stop-at-end --highlight-users
--output-ppm-stream - input.gource | ffmpeg -y -f image2pipe -vcodec ppm -r 30
…
-
```
Using the following command line:
gource -r 30 -1280x720 -s .5 --disable-progress --stop-at-end --highlight-users
--output-ppm-stream - input.gource | ffmpeg -y -f image2pipe -vcodec ppm -r 30
…
-
```
Using the following command line:
gource -r 30 -1280x720 -s .5 --disable-progress --stop-at-end --highlight-users
--output-ppm-stream - input.gource | ffmpeg -y -f image2pipe -vcodec ppm -r 30
…