-
**Describe the bug**
eth0 (bcmgenet) Ethernet stops working when plugged-in and hangs until a next reboot.
**To reproduce**
Boot Raspi OS, plug in Ethernet cable, observe kernel output.
**Expe…
-
Trying to install Kernel on fresh install of Pop!_Os 22.04 LTS.
I never make it to login screen.
journalctl --dmesg below.
### Environment
- Hardware model: Surface Pro 9
- Kernel vers…
-
I saw in the ESP-Hosted FG document that the Bluetooth stack for MCU will be released in the future, when will it be released?
I wanted to adapt the ESP-Hosted FG to the STM32H750, but I couldn't fin…
-
```
hi all, i am booting android ics in beagle board xm, after running the script
file
partions in sdcard has been made and when i put the sdcard in beaglexm and
connected the xm to the host pc …
-
```
hi all, i am booting android ics in beagle board xm, after running the script
file
partions in sdcard has been made and when i put the sdcard in beaglexm and
connected the xm to the host pc …
-
Hello ! I would like to use your project with my Nobis Stove.
I'm pretty sure that it use a micronova controller board :
-> The WIFI module use the IOT Agua platform from Micronova
https://nobi…
-
Hello, I have this error message
after setting up my hifiberry digi+ i/o board with darkice and a PI3:
Using config file: /etc/darkice.cfg
Using ALSA DSP input device: plughw:0,0
Using POSIX …
-
### The problem
Under the binary_sensor / rc_switch_raw we can define our own rcswitch protocol, but cannot use the code value, it's just a binary_sensor afterall.
Under remote_receiver / on_rc_…
-
Hi,
I'm trying to repair a Robomow RM510, and your schematic is a huge help.
My question is, how did you enter into the service menu to test the motors? It ask me to enter a 5 digit password.
Tha…
-
Make it possible to create custom parts and program your own logic:
1. Define the pins for the part (e.g., for an I2C sensor: GND, VCC, SCL, SDA, INT)
2. Write some code to implement the logic for…
urish updated
6 months ago