-
See #127
function: setResolution(addr, res)
line: bitResolution = max(bitResolution, getResolution(deviceAddress))
The max macro in setResolution() expands the call to getResolution() twice in…
-
Before submitting a problem please check the troubleshooting section
https://docs.openmqttgateway.com/upload/troubleshoot.html
**Describe the bug**
I hava geniune Arduino Uno and Arduino IDE tell…
-
if scratchPad[COUNT_PER_C] is ever zero a divide by zero will occur.
Saw this happen on a ESP32. I just put a check on scratchPad[COUNT_PER_C] and set it to 1 if it is ever zero.
if (deviceAddre…
-
I've added this issue on the off chance that it's the format of the .hex file that is triggering the failures.
Firstly I can successfully load the official LA104_APP_V1.03.hex and also the Ralim mo…
-
**Describe the bug**
Listing the information from a 6.3.0.12 saved configuration file gave the GPIOs starting from GPIO1, rather than GPIO0.
**To Reproduce**
decode-config.py -T Command -f …
-
I installed OneWire 2.3.5 on a recent enough arduino IDE (1.8.6) and trying to use this on ESP8266 (need wifi, so I can't use my teensies for this).
I tried powering the Vcc pin but it didn't reall…
-
- DC2DC converter is mounted upside-down
- connectors for BME280, DS1820, DHT22 are covered by nodemcu
- change value of resistors green led (power) - 470, yellow (status) - 470
- fix pins labels f…
-
### Basic Infos
ESP-01 ( 8266 ) Module still create AP after setup and successful log in as client. I think that should not be happening. It connects as client ok, gets IP where can I access the valu…
-
Hi! I'm trying to make work a DS1820 thermometer with ConfigurableFirmataWiFi firmware flashed on my NodeMCU 1.0 Amica ESP-12E board, but it does not work. Steps to reproduce:
- NodeMCU 1.0 Amica E…
-
Hello! Thanks for library! Its helped me a lot!!
is it possible to check internal sensor temperature of AC? (0x4E2a)
if payload
**1900bb00070000000f000111672010a0000000000000100000a62d9175160165** …