-
Since we changed the definition of "fraction of remaining natural gas reinjected" to mean after accounting for use onsite, it's possible for the model to break in the case that NG reinjection is turne…
-
Fugitive methane emissions from reinjection compressors are currently linked to the "site-level" sheet. Compressor emissions on the "site-level" sheet are based on measurements at gathering, boosting,…
-
Sorry for this is being a question instead of an actual issue, but I don't really find a proper description for what I try to achieve which I suppose should be a simple usecase.
I use Autofac in my p…
-
Gas Flooding compressor cell E18 although it doesn't make any difference in the results. Do you think we can replace with the following equation
@smasnadi @JSRuthe
=IF(Flood_gas_type=3,IF(Ga…
-
This is an intermittent error that has been puzzeling me for some weeks now. Sometimes, when I start our RCP Client this fails with the following error logs
`12.07.2021 15:46:37.513 [2bcb0ca164] [DEB…
-
I am helping Zhan by running OPGEE with updated flaring data. Zhan and I planned to share results with @arbrandt and @JSRuthe afterwards to work on a paper. OPGEE 2.0 runs are successful. I ran all fi…
-
This showed me a lot of errors in the following sheet's respective cells.
First I fixed,
Sour Gas reinjection compressor cell M78 and M79 changed to M77 and M78.
A similar fix needs to be don…
-
The site method fugitives sheet states that we assume the figures do not include gathering compressor, transmission compressor, storage compressor, or gas flooding compressor emissions. However, it do…
-
On the Gas Flooding Compressor sheet, older versions of the model calculated an "adjusted volumetric flood gas injection rate" that was reduced by the amount of recycled CO2 when using CO2 flooding. T…
-
I've come back to comparing OPGEE 2.0 and 3.0 for crude oil analysis. I've rediscovered an issue with gas reinjection compression that can cause major differences between the model versions for fields…