-
Can anyone help me to flash the firmware, especially the display.
The documentation is still in progress.
I tryed to upload with VS Code and PlatformIO but the board is in boot loop.
With my test…
-
All builds and installs fine.
According to similar GPIO wiring works fine.
After hacking hardware detection in rpihw.c, /dev/vcio is not found.
Is there another way to get it working on BPi?
Thx.
-
I can't quite figure out how the conversion of rgb -> rgbw when using the sACN mode is done so I wanted to know if there was some way to take into account the color temperature of the white LEDs in or…
-
Hi,
Is there a back view of an assembled x-2 hsrgb PCB or BOM for the rgb version?
Just wondering as next to the per key led there seems to be a spot for a diode but I haven't found any info on it.
…
-
There seems to be a segmentation fault when calling ws2811_fini in the nodejs bindings.
Any tips on how to fix that ?
Thanks !
```c++
void finalize(const Nan::FunctionCallbackInfo &info)
{
…
natcl updated
6 years ago
-
At the moment, only SPI provides support for RGBW strips - what if they're on a usbasp or arduino over serial ?
-
In raspberry-pi-pico-c-sdk doc, Section 3.2.2 Pg 37 on.
The Times specified in the code and on page 37, are T1=2, T2=5, T3=3 however the timing diagrams further down Fig 4 to 7 imply timings of T1=4 …
-
What is the process to add more lights to led_ble?
For ex., here is the list of commands/characteristics to be used with SP110E controller.
And I would like to add commands for SP107E (it controls t…
-
**Describe Your Problem:**
Hello, I'm getting following message in my HB log. I have no problem with the plug in, I'm only getting this error.
thanks you for your effort!
**Logs:**
```
[…
-
Hello, what setting shoud I use with GS8208?
![image](https://user-images.githubusercontent.com/47831723/110515875-2a578680-8109-11eb-8312-c2917ba33b3c.png)
Timig is in this datasheet: http://addr…