-
Hello, i ordered this with my skr mini e3 v3 but not used. It is possible to use it in another project with raspberry pi 4?
How can I connect it? I can not find if pinout for this board to be used. P…
-
### Description
Randomly the board will drive the steppers at the wrong settings.
### Steps to reproduce
1. Print
2. touch steppers
3. Burn fingers
**Expected behavior**
For the same se…
-
My printer has just developed the above fault,
Switch it on with the sd card in and I get the init fail warning.
SD card is working fine in my pc.
-
I just installed an E3 V3.0 on my Ender 3 Pro. This is regarding the 3 fan assignments and getting them to work correctly. I confirmed the following by checking function:
FAN0 (PC6) = Part cooling …
-
I recently flashed my cb1 with the following image: CB1_Debian11_minimal_kernel5.16_20230303.img.xz
after installing klipper / Mainsail I cannot access my SKR mini e3 v3 due to lack of serial/by-id…
-
Hello,
Is there a location for the Configuration.h and Configuration_adv.h files for the bin file: BIGTREETECH-SKR-mini-E3/firmware/V2.0/firmware-bltouch-for-z-homing.bin
If not, please upload thos…
-
Installed the SKR mini E3 V3 on my old Hanbot DRT printer. Seems to be working fine except for the hotbed. It starts heating up from the time you power up the printer. The heat keeps going up even if…
-
There is an **Ender 3 pro** printer in **stok**.
There is a **BIGTREETECH-SKR-mini-E3-V3.0** board.
When trying to build the firmware in **Visual Studio Code** gives an error
_**Error: Unknown en…
-
There is no documentation regarding max size (or resistance) of the heated bed.
I am currently replacing stock motherboard in Kobra Max with BTT SKR Mini E3 V3. I see that Kobra Max has additional…
-
Was using your guide on the tach 3-pin hotend fan from Orion and noticed that Klipper wasn't reporting the RPM when attached to my Huvud CANBUS pcb when attached to 5V endstops. https://ellis3dp.com/…