-
I'm trying to use SoapySDR with Python to capture ultrasound signals from a microphone/preamp. I have my RSP1a configured with a sample rate of 250kHz and a centre frequency of 125kHz and am using sd…
-
Hi.
I'm trying to compile master gr-sdrplay3 and everything works, however after doing a make install and running gqrx I'm not able to see in builtin source types sdrplay, while typing in Other sdrpl…
-
Hi, I have installed CubicSDR v0.2.6a and when i start and enter the ip address or my PI with an RSP1A attached, Cubic SDR reports that it can't find Soapy Remote. I now i have Soapy Remote installed …
-
Can IQ or audio output from an SDR be piped into this in realtime? Or, do you have plans to extend the decoder support of SDR's such as RTL-SDR or SoapySDR?
-
I'm trying to make on a Raspberry Pi 4.
Soapy is installed through apt (sudo apt install soapysdr-tools) but cmake complains with "Soapy SDR development files not found..."
-
```
$sudo systemctl status dump978-fa
● dump978-fa.service - dump978 ADS-B UAT receiver
Loaded: loaded (/lib/systemd/system/dump978-fa.service; enabled; vendor preset: enabled)
Active: a…
-
As a linux only user of SDRGlut, I saw you forked a SoapySDR driver for this incredible icom receiver.
As for I can see, it only builds on windows OS.
It seems to be related to serial communicat…
-
Hi,
Trying to read and load config from .ini file (created via SAVE in Lime Suite - tried with "Default" config)
Always fails as per following:
.........
File "C:\Program Files\PothosSDR\lib…
-
![screenshot from 2018-06-08 12-31-42](https://user-images.githubusercontent.com/33361944/41172327-26dd82ce-6b19-11e8-8278-e10ab6f0ef85.png)
![screenshot from 2018-06-08 12-32-19](https://user-images…
-
This might end up being a SoapySDR ticket, but I have evidence that it might be on the CubicSDR side. In either case, the docs might need updating.
I was able to go through the instructions, and th…