-
Hello,
I've found no way to get this board working with dual Z driver and dual Z endstop.
The second Z driver (Z2) was recognized, but the endstop resource never be used.
My actual configuration …
-
I'm unsure what is causing it, but I can only now successfully home my machine if I disable tmc_autotune for the X and Y motors. This used to work prior to updating today. Here's the relevant parts of…
-
In the example Stridemax_dual.cfg it appears that pins
spi_software_mosi_pin: stridemax_dual:**gpio4**
spi_software_miso_pin: stridemax_dual:**gpio3**
are incorrect per your pin out diagram of th…
-
They run for couple second but then this error massage ,and same error after restart.
My thorough research seams 8 mhz crystal on 429 version causing the problem need 12 mhz version please correct me…
-
Hi,
Probably I am in the wrong section- it is not an error/issue- but here goes
The Trinamic Evaluation, BOB and now also the stepsticks have pins for end stops on them (aliexpress)
How can acc…
-
I received an email asking about TMC2209 drivers in UART mode. I thought it best to move the conversation to a more public space so that the collective wisdom of the open source community can be harne…
-
I am driving a motor via UART and a TMC2208.
VACTUAL sets a velocity, and the example uses delay to timeout that call. However, I would like to run the motor for X-number of steps, then do somethin…
-
Hello all,
I am running Bart Drings 4_Axis_ Daisy_SPI CNC controller https://www.tindie.com/products/33366583/4-axis-trinamic-cnc-controller-for-grbl_esp32/
with BigTreeTech TMC 5160 V1.2 Drivers
…
-
Hello, i cannot configure my printer to home with this script.
Here's my config:
```
[autotune_tmc stepper_x]
motor: moons-ms14hs5p4150
tuning_goal: auto
sg4_thrs: 45
voltage: 24
extra_hyst…
-
Manta M8P with HermitCrap V1 was working fine with microprobe V1.2. After the pin get damaged and replaced with microprobe V2 it keeps given the some error, "Endstop z still triggered after retract" t…