-
Is there a best practice for creating a system of shells?
I want to have a shell for each of my devices and these should be aggregated under a parent shell of my system, where the devices are built …
-
Suppose you send an order like this:
![image](https://user-images.githubusercontent.com/295338/114864619-817c0580-9df1-11eb-8dc8-e8358ae38aa8.png)
- the base only covers the first 3 nodes, up to nod…
-
we used z7020 custom board.
I set an Zynq board as an AP by hostapd, the hostapd-openwifi.conf is as follows:
--------------------------------------------------------------------------------
interf…
-
I'm trying to get TW6869 TV capture card running, but I'm seem to be stuck at a DMA allocation issue. I think this is related to DMA coherent allocations. I've increased coherent_pool=32M, but that di…
-
I am having trouble running the libmetal demo on Linux. It seems the IPI device is not defined.
During boot the drivers say the IPI device is not defined.
Here is the boot message related to the r…
-
hello, i run your image on zcu102 , but it cannot connect to my fmcomms3, i have tried the image in two boards and all failed
the failed log is posted below
root@analog:~# ~/openwifi/fosdm-11ag.sh
…
-
FDI Spec (https://opcfoundation.org/developer-tools/specifications-opc-ua-collaborations/opc-unified-architecture-for-fdi/) [Released]
Commercial Kitchen Devices (https://www.beuth.de/de/technische-r…
-
I'm trying to get the kernel driver working in Petalinux 2017.4. I have a Vivado block diagram that has just an AXI DMA IP instantiated with the transmit/received looped back (just for testing, for no…
-
Hi,
I'm trying to transfer data stream with ZUC102. PS receives data from PL fifo using DMA, then transfers it through wifi. Incoming data rate is lower than 30MBps,DMA clock runs at 300MBps.
![2…
-
hello:
I'm want to use "Update FPGA" function, but I'm following the quick start and meet the error shown as below when running ./fosdem.sh
root@analog:~/openwifi# hostapd -dd hostapd-openwifi.conf …