-
### Aircraft Version
Development
### Description
Recommendations (Build 2882c22):
- Provide the ability to control the reception and volume of the audio output using the knobs in the VHF panel.
!…
-
```
This is more of a feature request then a defect. I would like to see the
VHF+ label added to the bands when the window is collapsed. This allows the
selection of transverters without expanding/col…
-
My openwebrx raspi image running very nicely. I'd like to run a tunable VHF/UHF receiver for our local ham group but the Web interface does not allow the receiver center frequency to be changed. I can…
-
Hello, I am looking to make a config for 144mhz wspr but when i enter the frequency in the config generator I always have error
pll.c should be in range [1 ... 1048575]
How does one enter the…
-
A-10 pilot suggests that we adjust frequencies.
Since the Hog only have one UHF and cant listen on both 261 and 251 at the same time.
Suggestions:
- Add another freq to AWACS? Is it possible for …
-
```
What steps will reproduce the problem?
1.In VFO mode, VFO A; set offset (menu 26) to any nymber, exaple 00.600
2.In SFT-D (menu 25) set it to - (negative)
3.Download the device configuration.
4.Lo…
-
Missiles have a "fire all" keybind.
I'd like the same thing for Ballistics, if possible.
My reasoning is that firing my AC/X from a specific keybind is one keypress quicker than firing it via a we…
-
Hello, I've made some big changes to the OpenRTX port, including (finally!) full power TX. So far it's only for VHF, but we'll figure it out. It also has proper VHF/UHF RX now. If you'd like, please u…
-
For investigation
-
Hi,
As I understand this module, it creates an Upper Sideband (USB) signal. Is it possible to create a mode switch and then take input audio on this device and create a Narrowband FM signal (NFM)?…