-
Before I go off and buy one, does anybody know if grbl will work on the Arduino Uno Wifi with a grbl shield?.
It appears to be an uno clone with the following differences.
https://store.arduino.c…
-
The RP2040 is a pretty capable, powerful, cheap, and most important of all, available microcontroller on these shortage times. I understand that the ATmega328P is easier to handle, and that this sugge…
-
First of all thank you for this great project.
The software is reasonably well documented, but unfortunately a schematic is missing to assemble the necessary hardware. In the list of necessary hard…
-
can you specify the lib versions you were using also the version of the ESP8266 ?
is it 2.4.2 or later or already 2.5.x ?
lot have changed since a year ago.
im trying to downgrade everything as for…
-
The main problem is that my heating is still using gas to heat up the heating water even though the PID is -100% or lower; I see heating going on (no hot water being used). Why is that? I can only sto…
-
I flashed this to ESP8266 NodeMCU. Does anyone know how the pinout would translate between D1 to the NodeMCU? I also assume that the board is not needed with NodeMCU because the MCU has the resistors …
-
Hooked up this board with an external uSD slot wired up for SDIO 4-bit mode as i was looking for high data rates.
On the ESP32 chip GPIO_2 and GPIO_7 have SD_DATA0 functionality.
On this board the …
-
A note that I've had success with this code on an MSZ-GE60/71/80 series using an M5 Atom Lite.
Crucially, I couldn't build the current develop branch to install this, but I was able to cherry-pick …
-
When I connect to the MQTT server it works, but after 10 - 30 seconds the broker gives a keepalive timeout and reconnects rightaway. The loop is continuously executed.
I tried different brokers but …
hutje updated
3 years ago
-
Intending to push V1.0, Soon, after any bugs are fixed, and the following features implemented.
- ~~Support for Celsius temperature display (both local/indoor and openweather)~~
- ~~Support for …