-
Hi @gknapp,
did you ever had, or noticed, an issue with the z-offset setting?
I leveled the bed, the z-offset is 0, when I start the print I wait to check if the filament is sticking well, otherw…
-
Last Friday I was browsing through the package list on https://chocolatey.org/ and noticed that when I would go from the current page to the next, the content would sometimes be the same, even though …
-
# Version Number
Marlin bugfix-2.1.x(May 19 2023)
# Bugfix or Enhancement
Bugfix
# Description
The Homing Command issues the machine to home first X, than Y and Z last.
If the Z-Axis is not…
-
I can run Stable Diffusion Web UI A1111 but i can't run ComfyUI, ideas?
I've AMD APU Ryzen 7 7700
```
Error occurred when executing KSampler:
HIP out of memory. Tried to allocate 72.00 MiB. GP…
-
### Problem Description
Error preparing Rocm 6.1.3 application with vintage hardware https://github.com/djygithub/craydgemm
### Operating System
NAME="Ubuntu" VERSION="22.04.4 LTS (Jammy Jell…
-
### Problem Description
rocm-smi --showpids
get_compute_process_info_by_pid, Not supported on the given system
get_compute_process_info_by_pid, Not supported on the given system
get_compute_proce…
-
This is a fresh install, and the gcode files just contain
```
;Generated from just_in_case.tmp.1719745022467.stl (hash: c984a5cf3c8d6d334d1c4b62464525414c446935)
; BEGIN DISPLAYLAYERPROGRESS SETTIN…
-
**Is your feature request related to a problem? Please describe.**
Cleaning clogged nozzles at a low Z height is difficult, especially within the first 20mm or so.
**Describe the solution you'd li…
-
Rust code inside vm_to_constrained.rs should be reduced and moved to be implemented in PIL instead.
This is more of a brainstorming issue to see if it's possible at all.
The syntax can of course…
-
I tried using your method for clearpath fault detection, but it faults out immediately and will not allow the motors to enter enabled state.