-
Only the card change is detected but never any transfer or data led activity visible. Only my green power led is always lit.
Tried every driver/boot version I could think of on my Amiga 1200 but the …
-
Initial marlin configuration has **Z_MIN_PROBE_PIN** and I don't see in manual what should it be. Currently my BlTouch doesn't work because of that I guess.
-
Hello everyone, is this released firmware up and running?
I just received the V2 and I don't want any more problems like with the v1.2.
Thanks and take care
https://github.com/bigtreetech/BIGT…
-
Setup: attempting to run from linux command line. Printer control board is a BTT skr 1.3 with Marlin 2.0.7.2 (latest), direct stepping and advanced ok enabled, buffer size increased to fit advanced ok…
-
here is a rudimentary drawing of how im using my drivers on an MKS-Gen L V1.0 bo…
-
I try to send a file (a g-code) using web ui, but it is not able to write sd card (trying with differents sd card)....transfert is shown completed (100%), but no files are on the media, althought I ca…
-
**Describe the bug**
I have a problem with my BL-Touch V3.1 on my Ender 3V2 controlled by an SKR Mini E3 V3.0 running [Ender3V2-SKRME3V3-BLTUBL-20221002.bin](https://github.com/mriscoc/Ender3V2S1/rel…
-
### Is there an existing issue for this bug?
- [X] I have searched the existing issues
### Required Troubleshooting Steps
- [X] I have followed these troubleshooting steps
- [X] I have tried…
-
A prototype of the MRR ESPE board, which uses 2 x 74HC595 shift registers to implement I2S stepper stream for the ESP32, is out. Most of the board design is based on the MRR ESPA board (many many less…
-
I've been trying to get a BLTouch setup with my Ender 3 and E3 Mini 1.2 board. But the firmware won't load and i get a TMC Connection Error.
What does this actual error mean?
I've tried compilin…