-
Title: Hydroxychloroquine in patients with COVID-19: an open-label, randomized, controlled trial
## Please paste a link to the paper or a citation here:
Link: https://doi.org/10.1101/2020.04…
-
The EKF node requires a `geometry_msgs/TwistStamped` topic that contains the measured speed and yaw rate of the vehicle. This can be calculated from wheel speed measurements using differential drive k…
-
I suggest you give more details about the 0.2% difference.
(Also I think it would be better to quote the ratio rather than the difference... making sure your PAM is generated using a dataset taken …
-
Hi,
Maybe I'm just too stupid, but I cannot even manage to add a second sensor.
I used the example and successfully connected a full-bridge loadcell to AIN0-AIN1.
Than I wanted to add a second fu…
-
When attempting to run a standard DE fitting process, e.g.:
> fit_1 = DE_fit.DEfit(pspl)
Python raises RunTimeErrors stemming from the multiprocessing library, which complains that the code is usi…
-
### Expected behavior
I'd expect fetch() to be faster (see below for details).
### Actual Behavior
I'm observing quite a lot of additional latency when using `fetch()` to gather a Result and …
-
I have the following error:
echo Entering ./mex
Entering ./mex
cd mex ; make octave
rm -f *.o
/usr/local/bin/mkoctfile -g --mex get_reads.cpp get_reads_direct.cpp mex_input.cpp read.cpp -I/usr/local/…
-
Hi Hugen,
here I publish my mods to almost completely fix the loss of dynamic above 300MHz when the DUT is a LPF tuned below but closed to 300MHz such as VHF/UHF duplexers.
The mods on my prototype …
-
- [x] Add 10k pull-up to reset line (#7)
- [x] Add diode in parallel to 10k pull-up reset resistor (#6)
- [x] Tie second pad on 16U2 crystal to ground (was not connected before)
- [x] Replace LDO with…
-
The readings I am receiving from the load cell through the ADS1256 fluctuate around 0.5lbs. This causes the motor to oscillate when trying to hold a constant pressure on the pressure. I have mitigated…