-
requested by "@Vin"
**Vendor/Model**
`Eachine Cvatar CineWhoop`
`Eachine F722 mini Flight Controller`
https://www.eachine.com/Eachine-Cvatar-142mm-6S-3-Inch-Cinewhoop-Duct-FPV-Racing-Drone-PNP-…
-
## Current Behavior
If I disable pitmode by switching to a power level on the VTX using the button, then I am able to switch between power levels 1 (25mw) to 4 (400mw) from INAV. What INAV is unable …
-
Firmware 1.5.8 Kavan V20: Telemetry Loss signal when I go to the INFO menu.
-
### Variant
PWM
### Control type
FOC
### Control mode
Voltage
### Description
Hi guys I’m trying to make a rc lawnmower project using 4wd
I have issues across both boards where the pwm control…
-
The Eachine Mini Cessna can no longer be connected with v1.3.3.33 (TX: Radiomaster Zorro, EdgeTX 2.9.3)
When I flash in v1.3.3.20 or use the original TX, the plane binds instantly.
Issue can be …
-
I'm binding an Eachine H8S 3D with Silver13 firmware to a Radiomaster Zorro with internal 4-in-1 and EdgeTX 2.9. According to the [multiprotocol manual](https://www.multi-module.org/using-the-module/p…
-
### Describe the bug
After using the new version my defined Channel/Band in the Settings do not match with my googles anymore.
Normaly I use R1 but now on my googles there is only noise. R3 works.
…
-
### Is there an existing issue for this problem?
- [X] I have searched the existing issues
### What part of EdgeTX is the focus of this bug?
Transmitter firmware
### Current Behavior
According to…
-
I'm coming from a Devo 10 with DeviationTX and internal 4-in-1. I'm trying to reimplement my models on a Radiomaster Zorro with EdgeTX and internal 4-in-1. When programming an Eachine H8S 3D with Silv…
-
## Current Behavior
Current implementation of the Tramp Power Protocol is too rigid in INAV for modern VTX units. There are currently four power tables that are implemented for 5G8:
25, 100, 200, …
jc9aj updated
8 months ago