-
I connected the HC-SR501 to GPIO14 and the light is switched on (and off) if the sensor detected a movement. Is there any solution to do that only at night? I thought about adding a TSL2561 but I foun…
-
I'm thinking to build a motion sensor accessory.
The sensor would be something like [this HC-SR501](https://learn.adafruit.com/pir-passive-infrared-proximity-motion-sensor?view=all) and if bought o…
-
Hi
When I boot my D1 Mini flashed with Tasmota is get this
00:33:00 MQT: tele/pirstairs/STATE = {"Time":"2018-07-07T00:33:00","Uptime":"0T00:00:15","Vcc":2.810,"Wifi":{"AP":1,"SSId":"vanderdrift…
-
Heya,
the Sonoff Basics got a new Board Layout.
GPIO14 is gone and now there is a GPIO2 (IO2 and its not a borehole!).
---
> **Flashing process is the same**
>
> Disconnect all power, h…
-
Hi all!!!
II connect wemo d1 with pir motion sensor. G->G,VCC->5v,Out->D5. I configure the module in generic mode and d5 to switch1.
When I start the module and trigger for the first time the senso…
-
when i chose 09 switch is always on and off
-
I am using a Sonoff Basic and configured the following Item to turn on/off my carport lights...
`Switch Carport_Lights {mqtt=">[HABbroker:cmnd/sonoff-11/POWER:command:*:default]"}`
It works gre…
-
I have added successfully a HC-SR501 to a sonoff th16 on GPIO 4, but I dont want the sensor to trigger the relay, I want it to only send MQTT message on state change ("Switch1": "ON" "Switch1": "OFF")…
-
Hai All,
Just to inform you guys, the [Tasmota Wemos Wiki](https://github.com/arendst/Sonoff-Tasmota/wiki/Wemos%20D1%20Mini) has been updated for RCWL-0516 Microwave Radar Sensor.
Greetz!
-
If this has been covered and the wrong location by all means remove :)
So I wanted to setup a PIR sensor that would bring on 3 security light in my back garden. I placed 3 sonoff basic inside [HAL…