-
## What is the feature?
### Description
It would be great, to add the possibility to enter min and max valve positions. When entered these values, the valve should
not close at once mor then th…
-
### The problem
I am unable to load google integrations since updating to Core 2024.5.2
### What version of Home Assistant Core has the issue?
2024.5.3
### What was the last working version of Hom…
-
Hi, I find that this plugin works well to control an actual Mill panel heater, but not for the Mill smart plug for connecting an old-fashioned panel heater. It reads the temperature from the socket co…
-
HI, I a newbie in HA so could you excuse me if my question is silly.
I installed and configure your blueprint to optimise my PV panels on my water heater consommation but it doesn't work.
in the log…
-
Both of these applications should make use of the entire Instrument Framework. Right now only TC uses Remote Control SMO subsystem to enable remote control of the heaters. The full stack should be imp…
-
Hi!
I'm having an issue with the heater from Ikhos warm slim.
I'm able to control the heater with smartlife, adjusting temperature, heating mode, target temperature.
But on Homeassistant I only c…
jmvaz updated
3 years ago
-
Intro: I followed the steps in the Wiki to install
1. required dependencies,
2. cloned the repo,
3. without make I'm doing an install of the AqualinkD by running `sudo ~/software/AqualinkD/relea…
-
Great work!
I would like to try something similar for the 370f version of the thermostat.
- Were you able to take over control in the end or did it remain with decoding work?
- Any advice befo…
-
When using e.g. VR32 for connecting one eBUS to another and providing access to a single device in the second bus on a dedicated address on the first bus, the communication timing is no longer specifi…
-
Hi.
I have an issue on setting the z1ActualRoomTempDesired.
Any change in any situation (SFmode/OpMode/Hc1RoomTempSwitchOn) doesn't set this value.
z1DayTemp seems not to work for this thermostat…