-
### Describe the bug
My 5” quad was flying just fine on Betaflight v4.2.10. I then flashed the quad with Betaflight fw v4.3-RC2 default PIDs, and on the first flight I’m getting what feels like glitc…
-
### Describe the bug
Holybro Kakute H7 Board showing extra UART in ports tab. It is named "LPUART1"
### To Reproduce
Connect to Betaflight using Holybro Kakute H7 and go to port tab
### Ex…
-
### Describe the bug
Updated 2 quads, one is on RC1 and the other on RC2, RC1 i used presets and clicked apply, but i have Zero OSD
Quad on RC2 (updated configurator) Presets dont show so i u…
-
Hi @Dlloydev.
Let me tell you first I really like your library, thank you for the job done.
Cutting to the chase, I believe, as title says, input and output of AutoTune function should be only poi…
-
### Describe the bug
when climbing the drone with a 6s battery in this firmwate, the accelerometer the drone is as if it had lost the reference of the accelerometer. keeps shaking all over and tr…
-
Currently I try to convert the Uvify Draco-Betaflight 3.1.5 Fork firmware to a normal Betaflight Unified target.
I am following the Guide and no big issue so far.
But I noticed some differences in o…
-
Hello,
I've just install EMS-GATEWAY v 1.6 via cables which goes to FW200
MQTT and Home Assistant works
I have been bought EMS-GATEWAY for monitoring boiler and thermostat and control of the warm w…
-
Three weeks ago, while in the look for a portable iron I ended-up purchasing a Miniware TS100 unit. I was petrified by the crudeness of delivered factory firmware and I was looking for alternatives. I…
-
Where can I find the values for the error log? I have a program that aborted twice around the same spot and I can't seem to figure out why. The kiln wasn't moved or touched in both cases.
```
Prog…
-
#### What happened:
##### Short version
When both `evictionSoft.imagefs.available` and `evictionMinReclaim.imagefs.available` parameters are set on Kubelet, they act as the upper and lower threshold…