-
I have a standard WS2812b strip of 24 LEDs, I have proved it works by connecting to a Arudino Nano and run some simple LED code.
I have tried with / without a level shifter.
Common ground (j…
-
**Describe the bug**
k3s exits when a lot of pods are busy, e.g when gitlab is updated
**To Reproduce**
Steps to reproduce the behavior:
start k3s, start some activities, wait
**Expected beha…
-
As far as I remember, the duet had 3 calculation times. Based on the use of filament, only one of them. Are the rest unfulfilled?
Why does not it show the number of the layer that is printing?
If yo…
-
I have this installed and working on a Genuine Rasberry Pi 3B+ with a 5" TFT touchscreen. Everything works yet every few minutes, sometimes longer, the octoprint program resets, I get a very brie…
-
Hi
i launched command make deploy-oisp-test and got this error
Error: validation failed: unable to recognize "": no matches for kind "MinIOInstance" in version "miniocontroller.min.io/v1beta1"
Mak…
-
Write clear, concise and in textual form.
The steam profile that currently comes with firejail cause issues with sound in Shadowgate (using pulseaudio). Without firejail, the sound works perfectly …
-
First release candidate for OctoPi 0.18.0
There are both 32bit and 64bit Based on RpiOS images available. Which give support to Raspberry Pi 4B 8GB and Raspberry Pi 400
The main change that woul…
-
**Describe the bug**
I am trying to setup a k3s cluster with 3 raspberry Pis and no matter what I try I keep getting an error with containerd on the k3d setup. I have followed all the instructions:
…
-
**Describe the bug**
SuperSlicer Crashes on launch.
**To Reproduce**
Steps to reproduce the behavior:
Attempt to open SuperSlicer.
**3D Model and Slic3r Configuration Export**
N/A
**Expected…
-
Is anybody else seeing layer shifts on BugFix 2.0.0 ? I'm seeing one or two of them on long prints. I'm seeing them on the X-Axis (and mostly in the negative X direction).
I'm running an IDEX m…