-
I will try to add support for the Prusa MMU 2.0 to Marlin as soon as I have a unit at hand. So just to avoid reinventing the wheel: is anybody already working on MMU 2.0 integration?
-
The G30 is supposed to probe one point and generate the Z offset. The stock FW actually did 2 probes and generated two results. M4MPMD probed once and generated one result. M1.1.x is probing the be…
see3d updated
4 years ago
-
Do you have the source for the MGN12H carriage by any chance? I think I'm seeing artefacts from the Belt running over the smooth idlers and I'd like to try a belt twist.
I would however need to mov…
-
I am am getting the following error while trying to run evaluation:
```
5254, 1]), 'targets_plaintext': b"bainbridge's", 'targets': array([7835, 9818, 31, 7, 1])}
{'inputs_pl…
-
### Description
BL Touch new 3.0 units not working with marlin on homing. Probe responds to M codes for deployment, stowing, and shows no errors, but when it comes to levelling the probe doesn't se…
-
It has been said the Spektrum system has less latency in many threads and on YT.
https://www.youtube.com/watch?v=_rxAPlYr9FQ
There is a 0-9ms latency inconsistency due to the OpenTx OS is not sync…
-
Today, ADVi3++ is still using the physical Z-endstop for Z-height measuring and because I was not confortable with the idea to remove the stop (I see it as a safeguard). However, I get some feedbacks …
-
How can one deal with idealized rigid elements? Are there penalty formulations for that?
-
Motion Magic does not seem to be the best sort of control system for the elevator, as it does not understand that gravity exists.
-
This seems like a low-hanging-fruit feature request
The MK3 mesh bed leveling is quite coarse, it only probes a 3x3 pattern. I had my heatbed exchanged because my old bed has a slight bow right whe…