-
I connected a device that was sending invalid packets to the nRF receiver, and this broke keyboard input after the receiver seemed to try parse the packets as keyboard packets. The RF packet parser ne…
-
Hi, first of all i wanted to thank you for this wonderful job of yours.
I am using a Gboard Pro by Itead which is basically an Atmega2560 with Nrf24 IRQ pin attached to pin PE7 of the atmega. I can u…
-
Hello, I'm looking for a way to connect rf24l01 with raspberry, but it seems gobot didn't support?
-
I'm trying _pynrf24_. I don't use IRQ in my device, but don't know how to use this library in this case. The `begin()` method seems to require the IRC pin:
``` python
def begin(self, major, minor, ce…
-
Två saker som måste till, en på servern och en i noderna:
1. Trädstrukturen måste finnas lagra i servern på ett sätt så man kan få ut vilka barn en viss nod har. Eftersom när man byter plats på en nod…
-
When setting up an NRF24 serial gateway it fails on my Arduino pro micro unless the CE and CSN pins are manually specified by adding the lines:
#define MY_RF24_CE_PIN 9
#define MY_RF24_CS_PIN 10
…
-
### Platform
ESP8266
### Assembly
I did the assebly by myself
### nRF24L01+ Module
_No response_
### Antenna
circuit board
### Power Stabilization
Elko (~100uF)
### Conne…
-
I got an Arduino nano with a NRF24L01 set up to work from the Raspberry pi. The nano couldn't communicate with the R Pi using the default linux IDE so I installed the ARM version of Arduino 1.8.0 foll…
-
we need a Rc remote to manually drive the car when we are asked. Therefore the new car must be adapted to also be driven manually.
-
Hi, when i run nrf24-scanner with crazyradio PA it keep scanning without showing and result.
i reinstall pyusb as suggested in one of the tickets, also tried to flash crazyradio firmware and set the …