-
I'm trying to use #define Speaker with my Ender 3 Pro so that I can play audio tones when a print finished, but when I uncomment that line I get no sound at all from the Ender 3 speaker/buzzer.
How…
-
I'd like to try out the code for the BTT SKR E3 Mini v2.0 board that's being worked on in #2. I understand that Eclipse is grblHAL's IDE of choice but I'd prefer to use something that's less of an in…
-
i wired up the mini ups to one of the end stop max pin's on the skr 1.3 as shown but when there is power loss it ignores it and uses the stored power to try keep printing and then stops with out lif…
-
Any one having issues getting a good compile. I started atom and it said a few updates were available and I did them. Now I can't get a working firmware.bin. I have a working one from a few weeks ago.…
-
Hello,
"Bigtretech skr mini e3 v3.0 32 bit”
BLTOUCH is already installed.
I am using the "Ender Extender 400XL (for Ender 3 PRO)" kit.
The print area is therefore oversized 400mm x 400mm.
C…
-
I've been researching for a few days trying to figure out if the simple metal fw is compatible with the skr1.3 board. My printrboard died and I'm trying to set the board up to work with my simple meta…
-
HI, i have 11-30V capacitive probe i been using on Ramps 1.4 till i buy SKR v1.4 Turbo for my Corexy printer. But with this board it doesnt work.
Its PNP NO probe connected to 12v PSU and signal…
-
Hi!
I have a skr 1.3 Board using the Flash Magic program and installing the boot jumper, I was able to flash the bootloader into the Board.
There is also a scr 1.4 turbo Board , but there is no boot…
-
### Description
Ender 3 - Skr mini e3 v2: I can not save to EEPROM from marlin or terminal. When I flash new firmware (bugfix 30/7-20) I do M502, M500 and get: echo:Error writing to EEPROM!
echo:E…
-
I get the following "file not found error" when I attempt to compile:
FileNotFoundError: [Errno 2] No such file or directory: 'G:\\User Folders\\Downloads\\BIGTREETECH-SKR-mini-E3-master\\BIGTREETE…