-
When the UI was overhauled, and configuration settings changed to be handled more generically, an inconsistency in the usage of settings ranges became more obvious, and problematic.
The entire issu…
-
**1. Issue**
If I recall correctly, the room temperature is taken as reference to which the tip is calibrated. (Or is it actually the internal resistance of the tip? 😅)
But that *(room temperature)*…
-
**Describe the bug**
#1 My new Pinecil reports undervoltage from several USB power sources which work perfectly fine on my TS80 (QC3.0 USB charger that I received with my TS80, Xiaomi 20000mah powe…
-
_This is a Request_
* **I have**
- [X] Searched previous issues
- [X] This is in _this_ firmware, not vendor "offical" firmware
- [X] This is not a bug in the vendor bootloader (aka DFU)
…
-
Three weeks ago, while in the look for a portable iron I ended-up purchasing a Miniware TS100 unit. I was petrified by the crudeness of delivered factory firmware and I was looking for alternatives. I…
-
Can we bring some inputs and outputs to the bottom of the board? Like how the microbit does it with a huge hole/connector. Obviously hard because of the perforation, but would it matter hugely if we h…
-
Bought a tip from Amazon, reviews where good.
But its the only tip that cant hold its temp, it fluctuates +5c, so 310 = 310c to 315c constant.
PID tuned, set DC for my 24V PSU
Not looking for a…
-
# Describe the bug
Not sure if this should be a feature request rather than bug. The vehicle welding rig requires the welding component kit, which requires a soldering iron. The soldering iron …
-
Hi there,
I am very pleased with this upgrade kit. And grateful for it. My prayers answered. However i did notice a few things inspecting the PCB. And just wanted to let you know. In case you decide …
-
Please edit this template and fill out all the information you can (where relevant). Failure to provide essential information can delay the response you receive.
* **I'm submitting a ...**
- […